Rms-technologies IMD23 W/ POLE DAMPING TECHNOLOGY Bedienungsanleitung PDF herunterladen (Seite 21)

RMS Technologies Page 21 Version 1.10

IMD23/23DE Manual 12/3/2007

8 TROUBLESHOOTING

The motor is not functioning correctly

Check if power is being supplied to the unit. If the shaft of the motor is hard to turn, power

is on. Next, check if the signal generator is supplying pulses correctly. Verify that the 5V is

being supplied to the opto couples either via a separate power source or the internal 5V

from Pin 3.

The motor is not moving

Verify that the 5V is being supplied to Pin 8.

The configuration module did not save my settings

Verify that you only have the main power on (12 to 48VDC). Even if the function generator

is powered on but no step pulses are being sent, the configuration module will not work with

the 23D unit. Be sure that nothing else is connected but the main power on pins 1 & 6

together for +PWR, and 2 & 7 are connected together for power GROUND.

My driver overheated and does not operate anymore

Be sure that you only used a maximum combination of voltage and current settings of

24VDC and 3 Amp Peak OR 48VDC and 2 Amp Peak. Going beyond these two combinations

will overheat the driver board and are no longer under warranty.

1 2 ... 16 17 18 19 20 21 22 23

Keine Kommentare

Rms-technologies IMD23 W/ POLE DAMPING TECHNOLOGY Bedienungsanleitung Seite 21